FixVault
Home › Chrysler › 1993 › Imperial › Repair and Diagnosis › Engine Performance › System › Engine Controls - Tests W/Codes - Body Control Computer › Self-Diagnostic Tests › Test 32A - Right BRAKELIGHT Out

Test 32A - Right BRAKELIGHT Out

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. Remove and inspect right upper/outer brakelight bulb. Check bulb socket condition, and clean or repair as necessary. If bulb is bad, replace bulb. If bulb is okay, put DRB-II in voltmeter mode. Turn ignition on. Check voltage of Brown wire terminal in bulb socket. Depress brake pedal. If voltage is more than 10 volts, repair open Black wire.
  2. If voltage is less than 10 volts, reinstall bulb. Disconnect light outage module 14-pin connector. See Figure . Check connector condition, and clean or repair connector as necessary. Connect jumper wire between terminal No. 8 (Brown/Red wire) and terminal No. 9 (Brown wire) of light outage module 14-pin connector.
  3. Depress brake pedal. If right upper/outer brakelight comes on, replace light outage module. Perform VERIFICATION PROCEDURE VER-1. If right upper/outer brakelight does not come on, repair open Brown wire. Perform VERIFICATION PROCEDURE VER-1.
About FixVault