Service Reminder Indicator (Sri) Light Reset Procedure

Note: Service Reminder Indicator (SRI) light is designed to be a reminder to service vehicle emissions control system. It is not an emissions warning system, only a reminder to perform necessary emissions servicing. Components to be serviced include PCV valve, oxygen sensor and some vacuum-operated components. SRI light will glow after a predetermined mileage.

1) To reset SRI light, ensure ignition is off. Connect DRB-II to engine diagnostic connector. Engine diagnostic connector is located in engine compartment, near PCM on all models except Dakota. On Dakota, diagnostic connector is located in right rear corner of engine compartment, taped to harness.

2) Turn ignition switch to RUN position. Copyright information and diagnostic program version will appear on screen for a few seconds. After a few seconds DRB-II menu will appear. At FUEL/IGN MENU, press "5" (ADJUSTMENTS) key. Press ENTER key.

3) At ADJUSTMENTS menu, press "3" (RESET SRI LIGHT) key. Press ENTER key. Display will read RESET SRI LIGHT ARE YOU SURE? (ENTER TO RESET). Press ENTER key.