FixVault
Home › Chrysler › 1994 › LeBaron GTC › Repair and Diagnosis › Engine Performance › System › Engine Controls - Tests W/Codes - Body Control Computer (Convert) › Self-Diagnostic Tests › Test 30D - All Tail Lamps Out Checking Left Pod Switch

Test 30D - All Tail Lamps Out Checking Left Pod Switch

NOTE: For connector terminal identification, see CONNECTOR  IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
  1. Turn park lamps off. Ensure all doors are closed. Disconnect left pod switch connector. See Figure . Check, clean and repair connections as needed. Measure resistance at left pod switch connector terminal No. 13 (Black/Orange wire). If resistance is more than 5 ohms, repair open Black/Orange wire between left pod switch connector and ground. If resistance is less than 5 ohms, go to next step.
  2. Using an external ohmmeter, test resistance between left pod switch terminal No. 5 (Pink/Dark Blue wire) and park lamp relay connector terminal "C" (Pink/Dark Blue wire). If resistance is less than 5 ohms, replace park lamp switch, located in left pod switch. If resistance is more than 5 ohms, repair open Pink/Dark Blue wire between park lamp switch left pod switch connector and park lamp relay connector.
About FixVault