Test 52C - Repairing Traveler Open Fused Ignition Feed
NOTE:
For connector terminal identification, see CONNECTOR
IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS
. Perform TEST VER-1 after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Turn ignition switch to OFF position. Gain access to traveler module. Traveler module is located in center section of dash. Disconnect traveler module 7-pin connector and Body Control Module (BCM) Black connector. Check connector condition and clean or repair connectors as necessary. Go to next step.
- Using an external ohmmeter, check resistance of Violet/Brown wire between BCM Black connector terminal No. 14 and traveler module connector terminal No. 2. If resistance is more than 5 ohms, repair open in Violet/Brown wire. If resistance is less than 5 ohms, go to next step.
- Check resistance of White/Black wire between BCM Black connector terminal No. 15 and traveler module connector terminal No. 1. If resistance is more than 5 ohms, repair open in White/Black wire. If resistance is less than 5 ohms, replace BCM.