FixVault
Home › Chrysler › 1995 › Cirrus LXi › Repair and Diagnosis › Engine Performance › System › Engine Controls - Tests W/Codes - Body Control Computer › Self-Diagnostic Tests › Windshield Wiper Test 2G - Wipers Not Working At All

Windshield Wiper Test 2G - Wipers Not Working At All

NOTE: Perform WINDSHIELD WIPER TEST 2F  before proceeding with this test. For connector terminal identification, see CONNECTOR IDENTIFICATION in BODY CONTROL COMPUTER INTRODUCTION. Perform TEST VER-1A  after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Disconnect right multifunction switch 7-pin connector. See Figure in INSTRUMENT CLUSTER TEST 5G  . Using scan tool in ohmmeter mode, check resistance of right multifunction switch 7-pin connector terminal No. 1 (Dark Blue wire). If resistance is more than 5 ohms, go to next step. If resistance is less than 5 ohms, repair short to ground in Dark Blue wire between fuse No. 15 (10-amp) and right multifunction switch 7-pin connector terminal No. 1, and replace fuse No. 15.
  2. Using an external ohmmeter, check resistance of HI/LO wiper relay coil. If resistance is not 65-90 ohms, go to next step. If resistance is 65-90 ohms, replace HI/LO wiper relay and replace fuse No. 15.
  3. Using an external ohmmeter, check resistance of intermittent wiper relay coil. If resistance is not 65-90 ohms, replace multifunction switch and replace fuse No. 15. If resistance is 65-90 ohms, replace intermittent wiper relay and fuse No. 15.
About FixVault