FixVault
Home › Chrysler › 1995 › LeBaron › Repair and Diagnosis › Engine Performance › System › Engine Controls - Tests W/Codes - Body Control Computer › Self-Diagnostic Tests › Test 109A - Traveler Blank Message Display

Test 109A - Traveler Blank Message Display

CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS - 3.0L article in ENGINE PERFORMANCE. Perform TEST VER-1 after each repair.
  1. Turn ignition off. Disconnect traveler module connector. Check connector condition and clean or repair connector as necessary. Turn ignition on. Using scan tool in voltmeter mode, check voltage on traveler module connector terminal No. 7 (Dark Blue/White wire). If voltage is less than 10 volts, repair open Dark Blue/White wire. If voltage is more than 10 volts, go to next step.
  2. Turn ignition off. Using scan tool in ohmmeter mode, check resistance of traveler module connector terminal No. 6 (Black/Dark Green wire). If resistance is more than 5 ohms, repair open Black/Dark Green wire. If resistance is less than 5 ohms, replace traveler module.
About FixVault