FixVault
Home › Chrysler › 1995 › LeBaron › Repair and Diagnosis › External Pages › Different car › Section 80 (Anti-Lock Brake System) › Test 16B › System Relay Circuit

System Relay Circuit

WARNING: This page is about a different car, the 1995 Plymouth Acclaim and 1995 Dodge Spirit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see wiring diagram.
  1. Using scan tool in voltmeter mode, check voltage on Brown/Black wire at ABS relay connector. If reading is less than one volt, go to TEST 16C. If reading is more than one volt, go to next step.
  2. Turn ignition off. Disconnect CAB 60-pin connector. Inspect, clean and repair connector as necessary. Using scan tool, check voltage on Brown/Black wire at ABS relay connector. If reading is less than one volt, replace CAB. Perform TEST VER-1A. If reading is more than one volt, repair short to power in Brown/Black wire. Perform TEST VER-1A.
About FixVault