Test 133E - Bus Short To Battery
WARNING: This page is about a different car, the 1997 Eagle Vision, 1997 Dodge Intrepid, 1997 Chrysler LHS, and 1997 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
Ensure all doors are closed and courtesy lights are off. Using scan tool in ohmmeter mode, measure resistance on anti-lock brake controller connector, terminals No. 11, 12 and 24 (Black wires). If resistance is 5 ohms or greater, repair applicable open Black wire. If resistance is less than 5 ohms, replace anti-lock brake controller.
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION
. For wiring schematics, see WIRING DIAGRAMS
in this article. Perform TEST VER-1 - VERIFICATION PROCEDURE
after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.