Verification Test
WARNING: This page is about a different car, the 1998 Dodge Intrepid and 1998 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Reconnect all previously disconnected components and wiring. If Body Control Module (BCM) has not been replaced, go to next step. If BCM has been replaced, use DRB (scan tool) to program all Remote Keyless Entry (RKE) transmitters, recalibrate ATC system doors and program other options as necessary.
- If ATC system has been repaired or battery has been disconnected, ATC door actuators must be calibrated. Start engine and use scan tool to calibrate door actuators. DO NOT allow vehicle to move during door actuator calibration. Turn engine off and go to next step.
- Turn ignition on. Using scan tool, erase Diagnostic Trouble Codes (DTCs). Turn ignition off and wait at least 5 seconds. Turn ignition on (engine off) and fully operate repaired system to verify correct operation. If system operates properly, go to next step. If system does not operate properly, go to TEST 1A: IDENTIFYING ATC SYSTEM PROBLEMS .
- If A/C-heater system operates properly, use scan tool to check for other BCM DTCs. If any BCM DTCs are present, go to TEST 1B: IDENTIFYING ATC SYSTEM BCM DIAGNOSTIC TROUBLE CODES test. If no BCM DTCs are present and original DTC cannot be duplicated, repair is complete.