FixVault
Home › Chrysler › 1997 › Sebring JXi, 2.4 X › Repair and Diagnosis › Body & Frame › Body, Cab Control Systems › Body Control Computer (Except Coupe) › Body Control Computer Tests › Power Door Lock Test 2C - Door Lock Driver Short Circuit

Power Door Lock Test 2C - Door Lock Driver Short Circuit

NOTE: Perform POWER DOOR LOCK TEST 2A  before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION  and WIRING DIAGRAMS  . Perform TEST VER-1A - VERIFICATION PROCEDURE  after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Disconnect BCM 20-pin connector located at junction block and ensure connector is clean and not damaged. See Figure in CHIME TEST 3A. Using scan tool in ohmmeter mode, measure resistance at terminals No. 10 (Orange/Black wire), No. 11 (Orange/White wire), No. 12 (Orange/Tan wire) and No. 13 (Orange/Brown wire) on BCM 20-pin connector.
  2. If resistance is less than 5 ohms, repair shorted door lock driver circuit, replace fuse No. 9 and replace BCM (relay in BCM will be damaged). If resistance 5 ohms or greater, replace BCM and replace fuse No. 9.
About FixVault