DTC P0505-D: Idle Air Control Motor Circuits
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION . For wiring diagram, see
WIRING DIAGRAMS article.
- Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Inspect PCM connector for damaged or pushed out terminals. Repair as necessary. Perform TEST VER-5A: ROAD TEST FOR OBD-II TROUBLE CODES . If PCM connector terminals are okay, go to next step.NOTE: For next step, see IAC DRIVER CIRCUIT ID table for IAC motor connector wire color identification and PCM CONNECTOR WIRE IDENTIFICATION table.
- Using an ohmmeter, check resistance of IAC motor driver No. 3 circuit between IAC motor connector and PCM connector terminal No. 48. If resistance is 5 ohms or more, repair open in IAC motor driver No. 3 circuit. Perform TEST VER-5A: ROAD TEST FOR OBD-II TROUBLE CODES . If resistance is less than 5 ohms, replace PCM. Perform TEST VER-5A: ROAD TEST FOR OBD-II TROUBLE CODES .
IAC DRIVER CIRCUIT ID
| Application | Wire Color |
|---|---|
| Driver No. 3 Circuit | Brown/White |
PCM CONNECTOR WIRE IDENTIFICATION
| Application | Wire Color | |
|---|---|---|
| PCM Terminal No. 48 | ||
| IAC Driver No. 3 Circuit | Brown/White | |