Wipers Do Not Park
- Check for open in Tan/Red wire between wiper motor connector terminal No. 4 and BCM connector C3 terminal No. 3. See WIRING DIAGRAMS . See Figure and Figure . Repair as necessary.
- Check for defective BCM. See BODY CONTROL MODULES - CONCORDE, INTREPID, LHS & 300M article. Repair as necessary.
- Disconnect wiper motor connector. Connect fused jumper between battery voltage and wiper motor terminal No. 1 or 2. Connect jumper wire between ground and wiper motor terminal No. 5. Using DVOM, check resistance between wiper motor terminals No. 4 and 5. DVOM should indicate short to ground once for each revolution of wiper motor. If short is not indicated with each revolution, replace wiper motor. See WIPER MOTOR under REMOVAL & INSTALLATION.