Pressure Bleeding
- Connect pressure bleeder to master cylinder using appropriate adapters. Remove rubber caps from all 4 bleeder valves. Install clear hose on bleed valve at one wheel. Place other end of hose in clean transparent container of clean brake fluid. Ensure end of clear hose is submerged in brake fluid.
- Open valve on pressure bleeder. Open bleed valve at least one full turn. Close bleed valve when brake fluid flow is clear and free of bubbles.
- Proceed to next bleed screw of brake bleeding sequence. See BLEEDING SEQUENCE table. Install rubber caps on all 4 bleeder valves. Close valve on pressure bleeder. Remove pressure bleeder from master cylinder. Fill master cylinder with brake fluid (if necessary). Install cap on master cylinder.