Breeze, Neon, Sebring Convertible & Stratus

Remove components for access to electrical connector at TP sensor mounted on throttle body. With electrical connector installed on TP sensor, turn ignition on with engine off. DO NOT start engine.
Using Digital Volt-Ohmmeter (DVOM), check voltage at center terminal on electrical connector for TP sensor with throttle valve closed (idle position). Voltage should be within specification. See 4-CYLINDER TP SENSOR SPECIFICATIONS table.
Slowly open throttle to full throttle and note voltage reading. Voltage should smoothly increase to specification. See 4-CYLINDER TP SENSOR SPECIFICATIONS table. Replace TP sensor if voltage is not within specification.

4-CYLINDER TP SENSOR SPECIFICATIONS

Application & Throttle Opening

Volts

Breeze, Sebring Convertible & Stratus ⁽¹⁾

At Idle

Greater Than.60 Volt

At Full Throttle

Less Than 4.50 Volts

Neon ⁽¹⁾

At Idle

.38-1.20 Volts

At Full Throttle

3.10-4.40 Volts

⁽¹⁾	Measure voltage at center terminal on TP sensor with ignition on. Voltage should smoothly increase when moving throttle from idle to full throttle.