FixVault
Home › Chrysler › 2000 › Intrepid Base › Repair and Diagnosis › External Pages › Different car › Section 113 (Door System - Rear) › Trim Panel › Installation

Trim Panel: Installation

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place trim panel in position on door.
  2. Connect the wiring harness clips to the trim panel.
  3. Connect the power window switch wire harness connector.
  4. Connect the rear door speaker wire connect.
  5. Connect the remote handle linkage.
  6. Hook the trim panel over the sheet metal flange.
  7. Insert the forward four way alignment guide into position. Insert the rearward two way alignment guide into position.
  8. Engage the three retaining clips to attach door trim panel to door sheet metal inner panel, up to three ratchet clicks.
  9. Install three screws to the bottom of the door. Tighten all screws 1.3 to 1.9 N.m (12 to 17 in.lbs.) torque.
  10. Install screw in the remote bezel and close the trim plug.
  11. Install screw in pull cup, and close the trim plug.
About FixVault