FixVault
Home › Chrysler › 2000 › Intrepid Base › Repair and Diagnosis › External Pages › Different car › Section 114 (Exterior Body Panels) › Front Fender › Installation

Front Fender: Installation

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place fender in position on vehicle.
  2. From inside engine compartment, install bolts to attach fender to upper rail.
  3. Connect hood prop, rod and support the hood
  4. Install fender bolts to lower radiator closure panel.
  5. Place fascia into position.
  6. Tighten fender bolt to the upper cowl. Use plug that come with fender to fill drilled hole in splash shield.
  7. Install fender bolt to lower cowl.
  8. Install splash shield plastic rivets to sill cladding.
  9. Install splash shield plastic rivets to fascia.
  10. Install headlamp assembly.
  11. Check fender for flush and gap.
About FixVault