Headlamp Leveling Motor - Export: Installation
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Be certain the replacement motor matches the configuration of the motor removed.
- Line up lugs on new motor with the corresponding openings on the headlamp housing making sure the ball stud on the motor lines up with ball stud receptacle on the lamp assembly. The receptacle can be moved by grasping the rubber boot area of the outboard lamp and moving by hand. Rotate the motor back into position to secure in place.
- Push down on outboard lamp until leveling motor ball stud snaps into place. Ensure that the ball stud is fully seated.
- Connect the headlamp leveling motor wire connector.
- Install the headlamp assembly on the vehicle (Refer to HEADLAMP UNIT ).
- Verify headlamp leveling motor operation.
- Check the headlamps for proper alignment. Align the headlamps if required (Refer to STANDARD PROCEDURE ).
NOTE:
Headlamps must be aligned with the headlamp leveling switch in the "0" position