Section 87 (Speed Control - Except Coupe): Servo: Installation
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- With throttle in full open position feed cable sleeve through hole in bracket, then align hole in speed control cable sleeve with hole in servo pin and install retaining clip. See Figure.
- Connect vacuum hose to servo.
- Connect electrical connector.
- Insert servo studs through holes in speed control cable and mounting bracket. See Figure.
- Install nuts, tighten to 6.7 N.m (60 in. lbs.).
- Install servo and bracket to stud plate in shock tower and tighten nuts.
- Connect negative battery cable. See Figure.