Concorde, Intrepid, LHS, Prowler & 300M

On column shift applications, go to next step. On floor shift applications, go to step 3 .
On column shift applications, if shift interlock does not operate properly, BTSI solenoid may be malfunctioning. See GEARSHIFT LEVER LOCKED IN PLACE under SYMPTOM TESTS. If ignition interlock does not operate properly, ignition interlock cassette on steering column must be replaced. Shift interlock cassette cable may only be adjusted once after installing NEW cassette. See IGNITION INTERLOCK CASSETTE under REMOVAL & INSTALLATION.
Remove gearshift lever handle. Remove console bezel. Move gearshift lever to Park and ignition key to LOCK position. If interlock cable is being replaced, remove pin to allow cable to "self adjust." Press locking clip by hand to secure adjustment. See Fig 1 .

NOTE: New interlock cable is equipped with a removable pin.

Fig 1: Adjusting Shift Interlock Cable (Concorde, Intrepid, LHS, Prowler & 300M)

Courtesy of CHRYSLER CORP.

If interlock cable is not being replaced, pin will not exist. Loosen locking clip on interlock cable to allow cable to "self adjust." Press locking clip by hand to secure adjustment. Install bezel on gearshift console. Install gearshift handle.