FixVault
Home › Chrysler › 2001 › Sebring Limited › Repair and Diagnosis › Body & Frame › Body, Cab Control Systems › Body Control Modules - Except Coupe › System Tests › Instrument Cluster Systems › No ORC Bus Messages Received

No ORC Bus Messages Received

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Connect scan tool to Data Link Connector (DLC) located under left side of instrument panel. See Figure . Turn ignition on. Using scan tool, attempt to communicate with Occupant Restraint Controller (ORC). If scan tool communicates with ORC, go to next step. If scan tool does not communicate with ORC, diagnose communication problem. See NO RESPONSE FROM ORC  under COMMUNICATIONS. If scan tool communicates with ORC, go to next step.
  2. Using scan tool, erase DTCS. Cycle ignition off and on and wait about one minute. Using scan tool, check for DTCs. If DTC resets, replace instrument cluster. If DTC does not reset, no problem is indicated at this time. Test is complete.
About FixVault