Specifications Index
SEBRING CONVERTIBLE, SEBRING SEDAN & STRATUS SEDAN SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | 105 Ft. Lbs. (142 N.m) | ||
| Brakes | |||
| Bleeding Sequence | |||
| With ABS | BLEEDING BRAKE SYSTEM | ||
| Without ABS | BLEEDING SEQUENCE | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | See GENERATOR APPLICATIONS table under DESCRIPTION . | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 14-18 psi | ||
| Thermostat R & I | |||
| 2.4L | ENGINE COOLANT THERMOSTAT | ||
| 2.7L | ENGINE COOLANT THERMOSTAT | ||
| Water Pump R & I | |||
| 2.4L | WATER PUMP | ||
| 2.7L | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | |||
| 2.4L(CAUTION: If oil pressure is zero at idle, DO NOT run engine at 3000 RPM.) | Oil pressure is 14 psi (.28 kg/cm2 ) at curb idle, and 25-80 psi (1.75-5.62 kg/cm2 ) at 3000 RPM. | ||
| 2.7L (CAUTION: If oil pressure is zero at idle, DO NOT run engine at 3000 RPM.) | Oil Pressure (engine at operating temperature): Curb Idle 34.5 kPa (5 psi) minimum 3000 RPM 300-724 kPa (45-105 psi). | ||
| Overhaul | |||
| 2.4L | ENGINE SPECIFICATIONS | ||
| 2.7L | Refer to appropriate Figure under SPECIFICATIONS . | ||
| Torque | |||
| 2.4L | TORQUE SPECIFICATIONS | ||
| 2.7L | Refer to appropriate Figure under SPECIFICATIONS . | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Drive Plate/Flex Plate Torque | N/A | ||
| Fuel System | |||
| Fuel Filter Location | FUEL FILTER | ||
| Pressure Specification | FUEL PUMP | ||
| Fuel Pressure Test Procedure | CHECKING FUEL DELIVERY | ||
| Fuel Pressure Release | FUEL SYSTEM PRESSURE RELEASE | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER & TIMING MARKS Wire routing is located in Figures. | ||
| Spark Plugs | SPARK PLUGS | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Lug Nut Torque | 100 Ft. Lbs. (135 N.m) | ||