FixVault
Home › Chrysler › 2001 › Voyager Base, 3.3 G › Repair and Diagnosis › External Pages › Different car › Section 1 (Body Control Modules) › System Tests › Windshield Wiper/Washer System › Rear Wiper Not Working In Intermittent Mode

Rear Wiper Not Working In Intermittent Mode

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2000 Plymouth Voyager, 2000 Plymouth Grand Voyager, 2000 Dodge Grand Caravan, 2000 Dodge Caravan, and 2000 Chrysler Voyager. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition on. Depress intermittent rear wiper switch to ON position. If indicator light on switch illuminates, go to next step. If indicator light does not illuminate, replace Heating/Ventilation Air Conditioning (HVAC) module. HVAC module is part of heating-A/C control assembly in center of instrument panel.
  2. Using scan tool, select BODY, HVAC, MONITOR SYSTEM, and then WIPER: REAR INT WIPE SW. Depress intermittent rear wiper switch to ON position. If scan tool does not display ON, replace HVAC module. If scan tool displays ON, go to next step.
  3. Disconnect rear wiper motor connector. Connect a test light between ground and terminal No. 3 (Brown/Light Green wire) at rear wiper motor connector. Ensure intermittent rear wiper switch is still on. Monitor test light for 30 seconds (minimum). If test light cycles on, and then off, replace rear wiper motor. If test light does not illuminate, replace BCM.
About FixVault