FixVault
Home › Chrysler › 2002 › Intrepid Base › Repair and Diagnosis › Transmission › Automatic Trans › Shift Interlock Systems › Adjustments › Gearshift Cable › Sebring Convertible, Sebring Sedan & Stratus Sedan

Sebring Convertible, Sebring Sedan & Stratus Sedan

  1. Apply parking brake. Remove set screw from side of gearshift lever knob. Remove gearshift lever knob, gearshift lever bezel and wiring. Gear selector bezel snaps on top of center console and indicates gearshift lever position.
  2. Reinstall gearshift lever knob and set screw. Ensure gearshift lever is in Park. Loosen gearshift cable adjuster nut at gearshift lever. See Figure . Move manual control lever on transaxle to Park. Manual control lever is lever on transaxle on which gearshift cable is installed.
  3. Ensure gearshift lever and manual control lever on transaxle is in Park. Tighten gearshift cable adjuster nut at gearshift lever to 19 ft. lbs. (26 N.m).
  4. Ensure engine starts only with gearshift lever in Park or Neutral and detent position for Neutral and Drive are within gate areas on gearshift lever. If engine starts with gearshift lever in any other gear range except Park and Neutral, or detents are not within gate areas, readjust gearshift cable. Reinstall gearshift lever bezel.
About FixVault