Power Mirror Motor

Remove front door trim panel to gain access to power mirror wire connector. See DOOR TRIM PANEL under REMOVAL & INSTALLATION.
Disconnect wire harness connector to power mirror switch.

Using two jumper wires:

Connect one to a 12-volt source.
Connect the other to a good body ground.
See POWER MIRROR MOTOR TEST table for proper wire connections at the switch connector. See Figure .

POWER MIRROR MOTOR TEST

Mirror Operation		Apply 12 Volts To Terminal No.	Apply Ground To Terminal No.
Driver's Side
Up		2	6
Down		6	2
Left		6	1
Right		1	6
Passenger's Side
Up		9	6
Down		6	9
Left		6	10
Right		10	6

If results shown in table are not obtained, check for open or shorted circuit. Replace mirror assembly as necessary.