FixVault
Home › Chrysler › 2002 › Neon LE, Automatic › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Manual Transmissions) › Back-Up Lamp Switch › Installation

Back-Up Lamp Switch: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install back-up lamp switch. Teflon tape or equivalent must be used on switch threads. Tighten switch to 24 N.m (18 ft. lbs.).
    CAUTION: Do not overtighten switch.
  2. Connect back-up lamp switch connector. (Figure).
  3. Lower vehicle.
  4. Verify back-up lamp operation.
About FixVault