FixVault
Home › Chrysler › 2002 › Prowler › Repair and Diagnosis › Engine Performance › Remove, Overhaul & Install › Fuel Injection System › Idle Air Control Motor › Installation

Idle Air Control Motor: Installation

  1. The new idle air control motor has a new O-ring installed on it. If pintle measures more than 1 inch (25 mm) it must be retracted. Use the DRB IAC Motor Open/Close Test to retract the pintle (battery must be connected.)
  2. Carefully place idle air control motor into housing.
  3. Install mounting screws. Tighten screws to 3 N.m (25 in. lbs.) torque.
  4. Attach electrical connector to idle air control motor.
About FixVault