Removal & Installation
- Disconnect negative battery cable. Pull cup holder out and depress tang in middle rear to release cup holder. Remove access cover from bottom of center bezel.
- Using Trim Stick (C4755), carefully pry between center bezel and instrument panel to disengage retaining clips. Remove screws attaching cup holder track and remove. Disconnect instrument panel center switch bank and A/C-heater control panel connectors.
- If A/C-heater control panel is to be replaced, remove screws attaching A/C-heater control panel to center bezel. To install, reverse removal procedure. Perform calibration test. See PROGRAMMING .