Power Module (Front): Installation
WARNING: This page is about a different car, the 2002 Dodge Grand Caravan and 2002 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
- Position the power module into the evaporator housing. Install and tighten the 2 screws that secure the power module to the evaporator housing. Tighten the screws.
- Reconnect the blower motor pigtail wire connector to the power module connector receptacle. Reconnect the instrument panel wire harness connector for the power module to the module connector receptacle.
- Flex both sides of the glove box bin inward near the top far enough for the rubber glove box stop bumpers to clear the sides of the glove box opening, then roll the glove box upward. Close and latch the glove box. Reconnect the negative battery cable.