FixVault
Home › Chrysler › 2003 › Intrepid SXT › Repair and Diagnosis › Body & Frame › Exterior/Interior Trim › Door System - Front › Trim Panel › Installation

Trim Panel: Installation

  1. Place door trim panel in position.
  2. Install wire harness clips into door trim panel.
  3. Connect the courtesy lamp, if equipped.
  4. Connect the radio speaker wire connector.
  5. Connect the power window switch wire connector.
  6. Connect the power door lock switch wire connector.
  7. Connect the power mirror switch wire connector.
  8. Connect the linkage to the handle assembly.
  9. Hook door trim panel over the sheet metal flange.
  10. Insert the forward four way alignment guide into position. Insert the rearward two way alignment guide into position.
  11. Engage rear retaining clips to attach door trim panel to inner sheet metal panel, up to three ratchet clicks.
  12. Install three screws in the speaker area.
  13. Install two screws in the instrument panel interface area.
  14. Install screw in the remote bezel, and close trim plug.
  15. Install screw in pull cup, and close trim plug.
  16. Install three screws to the bottom of the door. Tighten all screws to 1.3 to 1.9 N.m (12 to 17 in. lbs.) torque.
  17. Place speaker grille in position on trim panel.
About FixVault