Starter Motor: Removal

Disconnect and isolate the battery negative remote cable from remote ground post. See Fig 1 .

Fig 1: Negative Battery Cable
Courtesy of CHRYSLER CORP.
Raise vehicle.
Remove three bolts attaching starter to engine. See Fig 2 .
Remove battery positive feed wire from starter.
Remove starter solenoid assembly from transmission housing. Position the starter to gain access to the Connector Positive Assurance (CPA) wiring connector.

Fig 2: Starter 3.5L
Courtesy of CHRYSLER CORP.
Position jack stand beneath engine and slightly lift to relieve pressure from left engine mount.
Remove three left engine mount mounting bolts from engine block.
Jack engine up slightly to give more room to maneuver starter assembly.
Slide rear of starter motor out between catalyst and engine mount.
Disconnect posi-lock starter solenoid connector.
Remove the starter from vehicle.