Sun Sensor: Installation
- Connect the wiring harness connector to the sensor and position in the vehicle.
- Install the two sensor fasteners.
- Install the instrument panel top cover.
- Connect the negative battery cable remote terminal to the remote battery post.
CAUTION:
The sun sensor must protrude approximately 1/4 inch above the instrument panel top cover. This will ensure proper operation.
If the sensor does not protrude 1/4 inch, perform the following procedure:
- Confirm that the top cover is properly installed
- Remove the top cover
- Remove fasteners from sun sensor
- Install one 1/4-20 nut per fastener under the sun sensor so that it is shimmed higher
- Reinstall the sun sensor. Do not overtighten screw. If a longer screw is required, use 8-15 x 1 inch.