Pedal Position Sensor: Installation
- Connect wiring connector to pedal position sensor.
- Place sensor against mounting bracket and into brake pedal. Move carriage as necessary to align slot with pin. Install 2 mounting screws. Tighten screws to 66 INCH lbs. (7.5 N.m).
- Align the bulkhead connector mounting slot with its bracket and install it, locking it in place.
- Install silencer panel below lower steering column cover.
- Connect ground cable to negative post of battery.
- Connect scan tool (DRB-III(R)) to data link diagnostic connector located below steering column.
- Turn ignition key to ON position.
- Using scan tool, check for and clear any existing adjustable pedal fault codes.
- Test operation of adjustable pedals, memory sets (if equipped), and RKE (if equipped). If applicable, reset radio and clock.
- Recheck for any fault codes.
- Turn key to OFF position and remove scan tool from vehicle.
- Road test the vehicle to ensure proper operation of the adjustable brake system.
NOTE:
Make sure pin in pedal assembly fits into slot in sensor carriage when installing sensor.