FixVault
Home › Chrysler › 2003 › Voyager Base, 2.4 B › Repair and Diagnosis (Single Page) › Accessories & Equipment › Communication Devices › Electronic Control Modules › Sliding Door Control Module › Installation

Sliding Door Control Module: Installation

  1. Position the control module and install the retaining screw.
  2. Connect the control module electrical connectors. Slide the locking tab into the locked position.
  3. Install the appropriate door trim panel on the vehicle. Refer to Body for the procedure.
  4. Install the weather shield. Refer to BODY for the procedure.
  5. Connect the negative battery cable.
  6. Using an appropriate scan tool, check and erase any power door control module diagnostic trouble codes.
  7. Verify power door system operation. Cycle the power door through one complete open and close cycle.
About FixVault