FixVault
Home › Chrysler › 2003 › Voyager Base, 3.3 3 › Repair and Diagnosis › Body & Frame › Door Locks › Power Liftgate System › Pinch Sensor › Removal

Pinch Sensor: Removal

  1. Disconnect and isolate the negative battery cable.
  2. Remove trim panel from liftgate. Refer to BODY for the procedure.
  3. Disconnect the pinch sensor wire harness connector (Figure ).
  4. Remove screws holding the pinch sensor to liftgate.
  5. Feed the pinch sensor wire harness out of the liftgate and remove the sensor from the vehicle.
About FixVault