FixVault
Home › Chrysler › 2004 › 300M Base › Repair and Diagnosis › Body & Frame › Exterior/Interior Trim › Hood System › Latch Release Cable › Installation

Latch Release Cable: Installation

  1. Place cable in position on vehicle.
  2. Push cable through access hole in dash panel.
  3. Install release cable rubber grommet into access hole in dash panel.
  4. Install screws attaching hood latch release cable handle to the cowl side. Tighten screws to 2.3 to 3.4 N.m (20 to 30 in.lbs.) torque.
  5. Install cable clips.
  6. Place carpet into position.
  7. Install left wheel splash shield.
  8. Install left cowl side trim panel.
  9. Connect hood release cable ferrule and cable end to hood latch.
  10. Verify hood latch operation before closing hood.
About FixVault