FixVault
Home › Chrysler › 2004 › Crossfire Automatic › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (Clutch) › Pilot Bearing › Installation

Pilot Bearing: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate new bearing with Mopar high temperature bearing grease or equivalent.
  2. Start new bearing into crankshaft by hand, then seat bearing with clutch alignment tool.
  3. Lightly scuff sand flywheel surface with 180 grit emery cloth. Then clean surface with wax and grease remover.
  4. Install clutch disc and clutch cover. See CLUTCH DISC  and CLUTCH COVER  .
  5. Install the transmission. See MANUAL - REMOVAL & INSTALLATION .
About FixVault