Washer Fluid Level Switch - Intrepid: Installation
NOTE:
Use a new mounting grommet when installing a new sensor assembly.
Assure "flat" of sensor is aligned under the "ridge" of reservoir and that sensor connector is facing down in the fully seated position.
- Install new rubber grommet into reservoir.
- Carefully install sensor into reservoir and grommet. Care must be taken not to puncture reservoir or grommet (Figure ).
- Connect the wire connector to the reservoir fluid level sensor.
- Install the Washer Reservoir. Refer to WASHER RESERVOIR
- Connect the negative battery cable remote terminal to the remote battery post.