Trim Panel: Installation

Place trim panel in position on door.
Connect the wiring harness clips to the trim panel.
Connect the power window switch wire harness connector.
Connect the rear door speaker wire connect.
Connect the remote handle linkage.
Hook the trim panel over the sheet metal flange.
Insert the forward four way alignment guide into position. Insert the rearward two way alignment guide into position.
Engage the three retaining clips to attach door trim panel to door sheet metal inner panel, up to three ratchet clicks.
Install three screws to the bottom of the door. Tighten all screws 1.3 to 1.9 N.m (12 to 17 in.lbs.) torque.
Install screw in the remote bezel and close the trim plug.
Install screw in pull cup, and close the trim plug.