FixVault
Home › Chrysler › 2004 › Intrepid SXT › Repair and Diagnosis › Electrical › Gauges › Instrument Cluster › Instrument Cluster Mask/Lens › Installation

Instrument Cluster Mask/Lens: Installation

  1. Align mask/lens with instrument cluster and snap into place (Figure ).
  2. Snap seven retaining tabs holding mask/lens into place.
  3. Install the two screws to mask/lens (Figure ).
    NOTE: Tilt steering wheel down to gain access for instrument cluster installation.
  4. Install the instrument cluster into instrument panel. The instrument panel wiring harness connectors are self-aligning, mounted directly to the rear panel. A force of approximately 9 kilograms (30 lbs.) will be required to engage the cluster to the connectors and upper clips.
  5. Install the instrument cluster screws.
  6. Connect headlamp switch connector. Place the cluster bezel into position and snap it into place firmly.
  7. Install the two screws over upper cluster bezel in instrument panel brow area and all remaining attaching screws (four on Intrepid, Limited, and 300M, and five on Concorde).
  8. Install the items covering the bezel mounting screws.
  9. Install the one screw (Limited/300M) to cluster bezel

    To service any instrument cluster component, the instrument cluster must be removed from the instrument panel. Use the following procedure:

  10. Tilt the steering column down into the highest position.
  11. Install the steering column shroud cover.
  12. Install the instrument panel left end cap.
  13. Connect the negative battery cable remote terminal to the remote battery post.
About FixVault