- Reconnect all previously disconnected components and connectors.
- Obtain the vehicle's unique Personal Identification Number (PIN) assigned to it's original SKIM. This number can be obtained from the vehicle's invoice.
NOTE:
When entering the PIN, care should be taken because the SKIM will only allow 3 consecutive attempts to enter the correct PIN. If 3 consecutive incorrect PIN's are entered the SKIM will Lock Out the DRBIII for 1 hour.
- To exit Lock Out mode, the ignition key must remain in the Run position continually for 1 hour. Turn off all accessories and connect a battery charger if necessary.
- With the DRBIII, select Theft Alarm, SKIM and Miscellaneous. Then select desired procedure and follow the steps that will be displayed.
- If the SKIM has been replaced, ensure all of the vehicle ignition keys are programmed to the new SKIM.
NOTE:
Prior to returning vehicle to the costumer, perform a module scan to be sure that all DTCs are erased. Erase any DTCs that are found.
- With the DRB III erase all DTCs. Perform 5 ignition key cycles leaving the key on for at least 90 seconds per cycle.
- With the DRB III, read the SKIM DTCs.
Are there any SKIM DTCs?
- Yes: Repair is not complete, refer to appropriate symptom.
- No: Repair is complete.
|
All |