Door System - Front - Except Coupe: Latch: Installation
CAUTION:
Do not close door before adjusting the door latch. Door may fail to reopen.
- Position door latch on vehicle.
- Install screws attaching door latch to door end frame.
- Connect wire connector to power door lock motor.
- Connect lock and latch rods from outside door handle and key cylinder at door latch.
- Engage lock and latch rods to clips on inner door panel.
- Connect lock rod from lock button bellcrank.
- Position the rear glass run channel back and install the bolt and nut.
- Adjust door latch.
- Verify operation of door latch. Readjust if necessary.
- Install door trim panel (Refer to TRIM PANEL ) and water dam (Refer to WATERSHIELD ).