FixVault
Home › Chrysler › 2005 › 300 Base › Repair and Diagnosis › External Pages › Different car › Section 111 (Wiper System & Washer System) › Wiper Module › Removal

Wiper Module: Removal

WARNING: This page is about a different car, the 2003 Dodge Grand Caravan, 2003 Dodge Caravan, 2003 Chrysler Voyager, and 2003 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the hood latch and open hood.
  2. Disconnect and isolate the battery negative cable.
  3. Remove the wiper arms.
  4. Remove the cowl cover (Refer to COWL GRILLE - REMOVAL ).
  5. Disconnect the positive lock on the wiper module wire connector (Fig 1 ).
    Fig 1: Disconnecting Wiper Module Wire Connector
    G02676867Courtesy of DAIMLERCHRYSLER CORP.
  6. Disconnect the wiper module wire connector from the engine compartment wire harness.
  7. Disconnect the windshield washer hose from coupling outside the module.
  8. Disconnect the drain tubes from nipples on bottom of the wiper module.
  9. Remove nuts holding wiper module to lower windshield fence.
  10. Remove bolts holding the wiper module to the dash panel (Fig 2 ).
    Fig 2: Removing Wiper Module
    G02676868Courtesy of DAIMLERCHRYSLER CORP.
    11. CAUTION: Do not allow wiper module to rest on brake master cylinder reservoir, damage to brake system can result.
  11. Lift wiper module from weld-studs on lower windshield fence.
  12. Remove wiper module.
About FixVault