FixVault
Home › Chrysler › 2005 › 300 Base › Repair and Diagnosis › External Pages › Different car › Section 130 (Speed Control) › Cable-Speed Control › Installation › 5.9L Diesel - Auto. Trans.

5.9L Diesel - Auto. Trans.

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install (connect) end of speed control servo cable to speed control servo. Refer to Speed Control Servo REMOVAL /INSTALLATION .
  2. Install cable through mounting hole on mounting bracket. Cable snaps into bracket.
  3. Connect servo cable to throttle lever by pushing cable connector rearward onto lever pin while holding lever forward.
  4. Connect negative battery cables to both batteries.
  5. Before starting engine, operate accelerator pedal to check for any binding.
  6. Install cable/lever cover.
About FixVault