FixVault
Home › Chrysler › 2005 › 300 Base › Repair and Diagnosis › External Pages › Different car › Section 131 (Vehicle Theft Security) › Vehicle Theft Security › Standard Procedure › Configuring A New Module / Switch Operating Modes

Configuring A New Module / Switch Operating Modes

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

To configure a new module or to switch operating modes, a DRBIII® scan tool must be used.

  1. Hook up the DRBIII® scan tool to the Data Link Connector (DLC).
  2. With the key in the ignition, turn the key to the RUN position.
  3. After the DRBIII® scan tool initialization, perform the following:
    1. Select "Theft Alarm."
    2. Select "VTSS."
    3. Select "Miscellaneous."
  4. Once in the "Miscellaneous" screen:
    1. If you wish to configure a new module, select "Configure Module."
    2. If you wish to put the module into customer usage mode, select "Enable VTSS."
    3. If you wish to put the module into dealer lot mode, select "Dealer Lot."
About FixVault