FixVault
Home › Chrysler › 2005 › 300 Base › Repair and Diagnosis › External Pages › Different car › Section 229 (Wiper System & Washer System) › Wiper Module › Removal

Wiper Module: Removal

WARNING: This page is about a different car, the 2004 Dodge Grand Caravan, 2004 Dodge Caravan, and 2004 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the hood latch and open hood.
  2. Disconnect and isolate the battery negative cable.
  3. Remove the wiper arms.
  4. Remove the cowl cover (Refer to COWL GRILLE ).
  5. Disconnect the positive lock on the wiper module wire connector (Fig 1).
    Fig 1: Disconnecting Wiper Module Wire Connector
    G03586590Courtesy of DAIMLERCHRYSLER CORP.
  6. Disconnect the wiper module wire connector from the engine compartment wire harness.
  7. Disconnect the windshield washer hose from coupling outside the module.
  8. Disconnect the drain tubes from nipples on bottom of the wiper module.
  9. Remove nuts holding wiper module to lower windshield fence.
  10. Remove bolts holding the wiper module to the dash panel (Fig 2).
    Fig 2: Removing Bolts Holding Wiper Module To Dash Panel
    G03586591Courtesy of DAIMLERCHRYSLER CORP.
  11. Lift wiper module from weld-studs on lower windshield fence.
    CAUTION: Do not allow wiper module to rest on brake master cylinder reservoir, damage to brake system can result.
  12. Remove wiper module.
About FixVault