Power Steering Pressure Switch: Installation

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

This switch is used only with the 3.7L V-6 and the 5.7L V-8 engines.

Install power steering switch into power steering line.
Tighten to 8-11 N.m (70-100 in. lbs.) torque.
Connect electrical connector to switch.
Check power steering fluid and add as necessary.
Start engine and again check power steering fluid. Add fluid if necessary.