FixVault
Home › Chrysler › 2005 › 300 Base › Repair and Diagnosis › External Pages › Different variant/trim › Section 5 (5.7L Engine (Service Information)) › Intake Manifold › Removal

Intake Manifold: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove engine cover.
  2. Bleed fuel system (Refer to FUEL SYSTEM ).
  3. Disconnect negative cable from battery.
  4. Remove air inlet hose.
  5. Remove ignition wires from on top of intake manifold.
  6. Disconnect electrical connectors for the following components:
    • Manifold Absolute Pressure (MAP) Sensor
    • Fuel Injectors
    • ETC ( Electric Throttle Control )
  7. Remove wire harness from intake manifold.
  8. Disconnect brake booster hose, purge hose, and MUA hose ( Make Up Air Hose ).
  9. Remove EGR tube from intake manifold.
  10. Remove intake manifold retaining fasteners in a crisscross pattern starting from the outside bolts and ending at the middle bolts.
  11. Remove intake manifold as an assembly.
About FixVault