Cable - Park Lock: Installation

Fig 1: Ignition Key/Switch Positions

Courtesy of DAIMLERCHRYSLER CORP.

1 - LOCK

2 - ACC

3 - ON

4 - START

1. Verify that ignition key is in ACC (2) position. See Fig 1.
   Fig 2: BTSI Cable at Ignition Cylinder

   Courtesy of DAIMLERCHRYSLER CORP.

   1 - RETAINER

   2 - CONNECTOR

   3 - IGNITION CYLINDER

   4 - PARK LOCK CABLE

2. Install the park lock cable (4) to the ignition cylinder (3). See Fig 2. Secure the cable to instrument panel at retainer.
3. Install any instrument panel trim that was removed to access the park lock cable.
   Fig 3: Park Lock Cable at Shifter

   Courtesy of DAIMLERCHRYSLER CORP.

   1 - PARK LOCK CABLE

   2 - SHIFTER ASSEMBLY

   3 - SHIFT MECHANISM CAM

4. Route park lock cable towards shift mechanism.
5. Connect the park lock cable core to shift mechanism cam (3), and then secure cable housing to shift mechanism. See Fig 3.
6. Adjust the park lock cable.
7. If necessary, install the shield, covering the gearshift and park lock cables, to the floorpan and install the bolts to hold the shield to the floorpan.
8. Install the floor console assembly. (Refer to BODY/INTERIOR/FLOOR CONSOLE - INSTALLATION)