FixVault
Home › Chrysler › 2005 › Crossfire Base, 2D Convertible › Repair and Diagnosis › Suspension › Front Suspension › Suspension System › Wheel Alignment › Standard Procedure › Standard Procedure - Chassis Alignment Inspection

Standard Procedure - Chassis Alignment Inspection

  1. Observe the general information on chassis alignment inspection. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
  2. Drive the vehicle onto an electronic measuring system.
  3. Unlock the turntables and the sliding platforms.
  4. Install a brake pedal winch on the brake pedal.
  5. Attach the wheel sensors.
  6. Perform the initial measurement process.
  7. Inspect the vehicle level at the front and the rear axles and adjust if necessary. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
  8. Inspect the vehicle level at the front and the rear axles with an electronic inclinometer and adjust if necessary. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
  9. Inspect and adjust the rear axle toe. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
  10. Inspect and adjust the front axle camber and caster. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
  11. Inspect the rear axle camber. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
  12. Inspect and adjust the front axle toe. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
  13. Perform the final measurement of the vehicle.
  14. Detach the sensors.
  15. Remove the brake pedal winch.
  16. Carefully drive the vehicle off the measuring system.
  17. Lock the turntables.
About FixVault