FixVault
Home › Chrysler › 2005 › PT Cruiser Base, 2D Convertible, Automatic › Repair and Diagnosis › External Pages › Different car › Section 125 (Speed Control) › Cable › Installation

Section 125 (Speed Control): Cable: Installation

WARNING: This page is about a different car, the 2005 Dodge SX, 2005 Dodge SRT-4, and 2005 Dodge Neon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install retaining clip to cable at servo.
  2. Slide cable bell housing over servo mounting studs.
  3. Install servo mounting studs into bracket.
  4. Install 2 nuts at cable to servo and servo bracket, tighten to 7 N.m (60 in. lbs.).
  5. Connect electrical connector to servo.
  6. Connect vacuum hose to servo
  7. Rotate the throttle lever forward to the wide open position and install speed control cable clasp.
  8. Slide speed control cable into throttle cable bracket and engage retaining tab. Slide throttle cable into throttle cable bracket and engage retaining tab.
  9. Install the Throttle cable cover.
  10. Connect the negative battery cable.
About FixVault